all-tube head for electric guitar with two channels, including foot switch
With the Marshall DSL100HR, the British rock'n'roll legend has given its most popular all-tube head a well-deserved makeover, adding useful details to the tried-and-tested two-channel design for use in the recording studio and rehearsal room. The EL34 power amp offers a power reduction, while the equalizer tuning has been revised. furthermore, an emulated Output with Softube speaker simulation is now available.
With "Classic Gain" and "Ultra Gain", the Marshall DSL100HR has two channels that deliver every nuance of the typical Marshall sound
Typical Marshall sound in Clean and High Gain
The preamp circuit of the Marshall DSL100HR is based on three ECC83 tubes and offers two channels. Classic Gain" and "Ultra Gain" each offer two sound modes that cover the entire spectrum of the typical Marshall sound. From the sparkling Clean and juicy Overdrive for Blues to the biting high gain for modern metal, the Marshall DSL 100 leaves no wish unfulfilled.
The Marshall DSL100HR is designed in the unmistakable look of the British rock'n'roll company.
Variable Equalizer and premium reverb
Both channels of the Marshall DSL100HR share a common 3-band tone control for adjusting the sound. A sensitive reworking has slimmed down the bass range, which is often perceived as too full, without losing any of its punch. With the help of the "Tone Shift" function, the midrange can also be adjusted, so that scooped sounds are also available for hard metal. Last but not least, the Presence and Resonance controls allow you to tune the bass and treble response in the power amp. The integrated reverb effect can be adjusted separately for both channels and convinces with a terrific spatiality.
The Marshall DSL100HR is equipped with an EL34 power amplifier that delivers 100 watts or 50 watts of power.
EL34 power amplifier with power reduction
The power amplifier of the Marshall DSL100HR is equipped with the usual EL34 tubes, which deliver 100 watts of power. Accordingly, adequate volume levels are available for the rehearsal room or the club stage. Thanks to the integrated power reduction, the head can also be played with 50 watts. This modulates the voltage and operating point of the tubes so that the typical sound character is preserved.
Emulated Line Out and Line In
The Marshall DSL100HR is also equipped with an Emulated Line Out, which allows the guitar signal to be conveniently picked up both in the recording studio and on stage. The simulation of the classic Marshall 1960 Cabinet, developed in cooperation with the audio specialists at Softube, guarantees a particularly natural reproduction. The combined Line/mp3-In also allows playback of playbacks or backing tracks via the guitar amp.
On the rear panel, the Marshall DSL100HR offers an effects loop, emulated line out, line/mp3 input, and connections for footswitches and speakers.
The Marshall DSL100HR at a glance:
Two-channel all tube head for electric guitar
100 watts of power, reducible to 50 watts
Preamp with three ECC83 tubes
Power amp with two EL34 tubes and one ECC83 tube
"Classic Gain" channel with clean and crunch mode as well as controls for gain and volume
"Ultra Gain" channel with two overdrive modes and controls for gain and volume
Common 3-band EQ for both channels with tone shift function
Two Master volumes
Integrated reverb effect with separate controls for each channel
Serial FX loop with on/off switch
Emulated Output with Softube simulation of a Marshall 1960 cabinet
Silent recording capability (please refer to the manual!)
Line/mp3 input
MIDI In
Speaker connections for guitar cabinets with 4 Ohm, 8 Ohm or 16 Ohm impedance
Marshall PEDL-90012 footswitch included
Compatible with the optional Marshall PEDL-91016 6-way footswitch (allows direct recall of all sound modes, changing Master volumes, and turning the effects loop on or off)
Marshall DSL video:
Features:
Manufacturer:
Marshall
Power Output (Watt):
100
Stereo:
No
Tubes (Poweramp):
4x EL34
Number of Channels:
2
Amp modeling:
No
Reverb:
Yes
Internal Effects:
No
Effects loop:
Yes
Recording Output:
Yes
Headphone Connection:
No
AUX Input:
Yes
USB Connection:
No
MIDI Interface:
Yes
Foot Switch Connection:
Yes
Incl. Foot Switch:
Yes
Speaker Connection:
4, 8, 16 Ohm
Width (mm):
740
Height (mm):
274
Length (mm):
242
Weight (kg):
24.2
Marshall DSL100HR 2-Channel Valve Head 100W (Black)
Marshall JVM410H 4-Channel Valve Head 100W (Black)
Marshall SV20H Studio Vintage Valve Amplifier Head 20W (Black)
Marshall Studio JTM ST20H Head
PRS MT15 Guitar Amplifier Head