Fender Standard Series Telecaster Neck PF

I think a lot of the hassle and aggravation you read about online that partscaster builders get, sometimes comes about when trying to get a Fender neck installed on a cheap body they've picked up on Ali Express for 20 quid. I've had no such problems. I took one of my neck bolts and screwed it to the correct depth, into all the pre-drilled pilot holes, before I took the neck anywhere near the body. Then after pushing the neck home into the pocket as per the instructions show, I tightened up the screws and installed the strings. Then, and here's a useful tip, with it in tune, and the guitar pointing away from you, loosen the the neck bolt screws off again, very slowly, ignore all the creaking noises; that's the neck being pulled into the pocket as tight as it will ever go; and will give your guitar a sustain comparable to a guitar with a set neck.

Found the item I needed for a guitar build a lot cheaper here than any other supplier. A few days later, item arrived well packed and as I had expected, no complaints!