DOEPFER A-100LCB Low Cost Base 6 HE incl. A-100PSU2
6U low cost base including PSU3
The Doepfer A-100LCB is a low cost base for the A-100. The A-100 Low Cost Base has the same width as the A-100 Low Cost Cases (A-100LC6/LC9) and is planned as a base frame for the A-100 Low Cost Cases. But it can be used also as a stand alone unit. One power supply (PSU2) and two bus boards are built in.
The A-100 Low Cost Base has two rows for modules available: one with horizontal alignment and another 45 degrees inclined row. The useable width is the same as for the Low Cost Cases, i.e. 84 HP. The bus boards are located in the rear area (even those for the modules that are mounted in the front row). This was necessary to take advantage of the full height of the front area for installation of A-100 modules. The max. depth for modules in the front row is ~70 mm.
The main features of the A-100LCB include:
Low Cost Base for the A-100
Outside: about 445 (width) x 80 height (front) / 190 height (rear) x 385 (depth) mm
Inside: 2 x 84 TE x 3 HE
Useable width: 84 HP
Useable depth of the front row: ~ 70mm
Useable depth of the top row: ~ 110mm (reduced to ~ 100mm in the power supply area) (useable depth is measured from inner side of the front panel until end of the pc board of the module)
Mains voltage: 115v ~ 230v or ~ (please specify when you finish order)
The PSU3 switching power supply built into the A-100LCB processes an input voltage of 100-240 volts AC and is therefore suitable for use in the USA or worldwide, for example. Please note that we do not supply a suitable power cable outside the EU.
Features:
Manufacturer:
Doepfer
Rows:
2
TE / HP:
168
Depth (mm):
110
incl. Power Adapter:
Yes
Power Supply:
Adapter, internal
Output + 12 V (mA):
2000
Output - 12 V (mA):
1200
Output 5 V (mA):
4000
Doepfer A-100LCB Low Cost Base 6HE incl. A-100PSU2
Intellijel 7U Performance Case 104HP (Stealth Black)
Befaco 7U Case
Moog 60 HP Powered Case