The proven Fame MS power amplifier series is extended with the models MS 2002 D, MS 2004 D and MS 10002 D by three digital power amplifiers with excellent sound characteristics. Due to the compact design with only one height unit these power amplifiers are equally recommended for fixed installations as well as for mobile use.
Values
The Fame MS 10002 D is a 2-channel power amplifier with a power of 2x 1000W at 8 Ohm with a distortion factor below 0,5% and a frequency range from 20 to 20.000 Hz. The digital power amplifier convinces by its reliability as well as by its robust performance which guarantees excellent power values even at higher demands and load peaks.
Safety
Extensive protection circuits protect the power amplifier from overload and three temperature-controlled fans ensure smooth, virtually noiseless operation.
Clearly arranged and user friendly
The front of the Fame MS 10002 D is clearly arranged and user friendly. In addition to the on/off switch, the front panel contains the ratchet controls for adjusting the signal amplification of the respective channel as well as LEDs for status and level displays. The level indicators work in two steps (-20dB/-10dB) to reflect the intensity of the signal gain.
When the "Clip" LEDs light up, the input gain should be reduced to avoid distortion or even damage. Finally, the Protection LED lights up as soon as protection mechanisms of the power amplifier intervene in the operation.
Universally applicable!
The signal inputs are designed as combojacks(XLR and 6.3 mm jack), the output connectors as Speaker Twist jacks. Two different modes are available (stereo or parallel), which can be set via the switch on the back of the amplifier.
In stereo mode, both channels of the power amplifier operate independently with a separate input channel, so that two independent speakers are connected to the outputs. Parallel operation allows a signal to be fed to both outputs via one of the inputs. Each channel drives its own speaker with independent effect. The remaining signal input can be used to pass the signal to other amplifiers.
I bought this amplifier for 2 18-inch ultimax for home theatre, but my receiver output is RCA and the input of the amplifier is XLR, I cannot use its full power, so I bought a Behringer crossover and I increased it about a few db. The sound is very punchy and absolutely scary, all the walls and the floor of the room are shaking and I feel my room gonna be rip apart. I can highly recommend that.
Craftsmanship
Price/Performance
Performance
Operating comfort
Features
4 from 4 found this review helpful
You have already rated this review.
Was this review helpful?
You have already reported this review.
Report this review
Delete this review
Are you sure you really want to delete this review ?
Crown XLS 2502 DriveCore2 Serie 2x 775W @ 4Ohm
Crown XLS 1502 DriveCore2 Serie 2x 525W @ 4Ohm
Fame Audio MS 8002 Amp 2x 820W / 4 Ohm
Fame Audio MS 8002 DSP
Behringer NX3000