Audio-Technica ATM350 Condenser Clip-On Microphone

Supplied with Audio-Technica’s versatile UniMount® clip and new violin mount, the low-profile ATM350 is an exceptional cardioid condenser microphone designed to clip to brass, upright bass, reeds, piano, snare, toms, and violin. The microphone offers a crisp, clear, well-balanced response, even at high SPLs. It features an integral 80 Hz hi-pass filter on the in-line power module. Its cardioid polar pattern reduces pickup of sounds from the side and rear for effective protection against feedback.

• Element: Fixed-charge back plate permanently polarized condenser
• Polar Pattern: Cardioid
• Frequency Response: 40-20,000 Hz
• Low Frequenzy Roll-off: 80 Hz, 12 dB/octave
• Open Circuit Sensitivity: –49 dB (3.5 mV) re 1V at 1 Pa
• Impedance: 50 ohms
• Maximum Sound level: 149 dB SPL, 1 kHz at 1% T.H.D.
• Dynamic Range (typical): 122 dB, 1 kHz at Max SPL
• Signal-tO-Noise Ratio: 67 dB, 1 kHz at 1 Pa
• Phantom Power Requirements: 11-52V DC, 3.5 mA typical
• Switch: Flat, roll-off
• Weight: (MICROPHONE) 14.5 g (0.5 oz)
• Weight: (POWER MODULE) 81.2 g (2.9 oz)
• Dimensions: (MICROPHONE) 37.8 mm (1.49") long, 12.2 mm (0.48") diameter
• Dimensions: (POWER MODULE) 92.9 mm (3.66") long, 18.9 mm (0.74") diameter
• Output Connector: (POWER MODULE) Integral 3-pin XLRM-type
• Cable: 4.0 m (13.1') long (permanently attached to microphone), 3.2 mm (0.13") diameter, 2-conductor shielded cable with TA3F-type connector
• Accessories furnished: AT8542 power module; AT8418 UniMount® microphone instrument mount; AT8468 violin mount; soft protective pouch